Remove the outlet hole using offset tin snips.
Proper gutter downspout placement.
The downspouts can be buried or positioned to carry that water away from the house.
Trace around the inside of the outlet to mark the downspout hole on the gutter.
Cut a two inch long notch in the front lip of the gutter with tin snips to join a rain gutter section.
If necessary shim out the back of the gutter with wood blocks.
One easy way to prevent water from seeping into the home is to keep gutters clean so debris does not prevent water from flowing through the downspouts.
Drill a inch diameter hole through the center of the circular outline.
Attaching the downspout outlet and caps 1.
Downspouts should enable draining at a steep pitch so water travels away from the foundation rather than pooling in the surrounding area and eventually seeping into the house.
Mark the location of the downspout outlet.
Here are some guidelines for placement of downspouts.
Choose green snips if you re cutting clockwise and red tin snips if.
Snap the sections together.
Downspouts should not discharge where water may pool close to the house and foundation.
Placing the measuring tape on the downspout make a mark with permanent marker on both ends.
Project step by step 20 cutting the gutter.
Place the measuring tape on the downspout again but this time deducts 2 inches away and mark the position.
Proper placement of downspouts is the key to keeping water away from the home foundation.
The high elevation of this rear two story deck coupled with a very steep slope at the end of the deck required the use of scaffolding for this gutter and downspout installation.
Gutters and downspouts are not expensive and they play a vital role in the roof doing its job.
Measure again and deduct another 2 inches.
Fasten the downspout to the wall with straps at the top and bottom and at 6 foot intervals.
Gutter placement people usually think that gutters should be placed right on the roofline.
For any house it s important to remove the water that runs off the roof as quickly as possible.
As a general rule at least one downspout should be placed per every 40 linear feet of gutter.
It s much easier to join sections on the ground than to work from the top of a ladder.
Attach the outlet.
To do this turn the gutter upside down and place the outlet on top.
In turn rainwater will run behind gutters that hang too high deteriorating the fascia boards along the way.
If the downspouts do not allow water to flow out of the gutter system freely and do not channel the water away from the home then the house could be susceptible to issues such as roof rot foundation damage and landscape erosion.
This is incorrect because rainwater pulls back up on the underside of the roof and it drips down under the roof.
Measure from the corner of your home to the center of the downspout.
Use a downspout outlet to mark the location of the downspout on the low end of the gutter.