Pull the cable through with a fish tape.
Pull wire through insulated wall.
Support cables at 4 1 2 inch intervals with appropriate staples or clamps.
The best advice for fishing wires through insulation is avoid it if you can the potential is always there to damage the vapor barrier or bunch up insulation leaving cold spots in the wall.
Here s where you can get piano wire.
Feed cables through the holes.
When you re installing a new electrical circuit or running speaker cables in your home you have to run the wires inside your finished walls.
Attach the cable to the pull cord in the attic crawl space and pull the cable out with the cord.
I ll be showing tricks to cut lots of time off fishing wires in walls.
If you must fish wires through exterior walls the best tip is to avoid spinning the flex bit until you make solid contact with the wood you plan to.
I also have to do the same with the ceiling which is also insulated.
Sure there are certain techniques you can t use through insulation but there are always work arounds.
For more in depth informatino about running fis.
Does anyone have any advice on how to best pull the wires through the insulation whithout bunching it all up i am assuming they are bats of insultation i haven t.
Then pull the cable through the wall plate and out the next wall box opening.
Run electrical cable through walls and across ceilings without tearing them apart.
Running a cable down an insulated cavity wall.
The tongue will soon become your favorite tool and will last you for years to come.
Make sure that someone holds the opposite end of the cable securely while you fish it to the next location to avoid pulling the cable into the wall where you can t reach it.
Be sure to leave enough slack on both ends to make connections.
Unfortunately i have to pull the wires through the wall that is common with the house and therefore insulated.
Strip the end of the sheathing attach the wires to the fish tape and tape them in place.
How to snake wires through insulation.
Tape the end of the fish tape tightly onto the cable with electrical tape.
Use a fish tape or a fish stick a rigid pole for pulling wires when you need to pass them through the wall plates to the floor above or below the one on which you re working.
Carefully extend the fish tape from one opening to the other.
Learn how with this video.
With the wire attached pull the tongue completely through from the far end and you have your wire.
Make sure the tape is smooth so the cable can slide through the opening.
